The sunn Forum
Miscellaneous => Site Improvement => Topic started by: brennansrevenge on July 26, 2005, 05:52:45 pm
-
i've got the wiring diagram, and replaced the transformer and 90% of the circuits, but can't stablize my power transformer.
i'm burning up the R43 330 ohm resister. any thoughts?
http://pg.photos.yahoo.com/ph/dcacolici@sbcglobal.net/album?.dir=/4096&.src=ph&.tok=phFOXXDBxkb3AZGo
-
My first thought is that C15 is leaky, drawing a high current through R43 and CR1. Have you replaced that? Is there any sign of abnormal operation, like swelling or heat?
-
abnormal operation?? sorry i just laughed because it hasn't operated since 1994. thank you for the response, i do appreciate the help!
i did replace all of those components in their proper arrangement.
do you think that a shorted tube or cap can cause a large voltage to ground?
-
Of course. If the cap is shorted, or has a low DC resistance due to age or poor dielectric, then R43 will have to drop all of the voltage from the transformer. In this case, that's 55 volts.Since P=E^2/R, R43 has to dissipate at least 9 watts. What is it rated at?
-
all resisters are rated for 1/2w, except for the pots, and some other specific resisters.
i've been talking with Joe Arthur on the Q&A side and took some measurements:
i did measure the diode and it's good. the caps are going the correct direction, and finally readings: R44= 6.5K (10K) and R45=14K(18K)
by the way when i am blowing R43, the standby is off, so only the heaters are going.
I checked caps 15,16,19, & 20 and they read over 15K of resistance, they build resistance to about 150K.