« previous next »
Pages: [1]   Go Down

Author Topic: 200S: Bringing it up the first time  (Read 2064 times)

0 Members and 1 Guest are viewing this topic.

Offline Greg_M

  • Sr. Member
  • ****
  • Posts: 198
200S: Bringing it up the first time
« on: February 15, 2011, 11:12:12 am »
Major gut and retro on the 200S and now it is ready to see if I did it right.

I thought I would bring it up on a variac without tubes and see if anything sizzles.

Any suggestions or ideas?
Report to moderator   Logged

Offline Greg_M

  • Sr. Member
  • ****
  • Posts: 198
Re: 200S: Bringing it up the first time
« Reply #1 on: February 15, 2011, 12:48:53 pm »
So far so good.
Had it at 120v for about an hour and no stink, smoke or excessive heat. A very slight hum from somewhere.
No speakers plugged in



Guess I will try the tubes that came with it first.
A couple of Peavey 6550As
Report to moderator   Logged

Offline Greg_M

  • Sr. Member
  • ****
  • Posts: 198
Re: 200S: Bringing it up the first time
« Reply #2 on: February 15, 2011, 05:34:57 pm »
Success !

Found one pin that I had forgot to solder on the 6AN8. That kept me going for a couple hours.

Now for some nice new tubes.

Wahoo
Report to moderator   Logged
Pages: [1]   Go Up
« previous next »