« previous next »
Pages: [1]   Go Down

Author Topic: will this work?  (Read 1408 times)

0 Members and 1 Guest are viewing this topic.

Offline sunnsunnsunn

  • Jr. Member
  • **
  • Posts: 4
will this work?
« on: February 04, 2012, 09:30:57 pm »
i have an original and reissue model T.  currently i run the one of the amps to a sunn 412 but i was wondering what marshall cab could i use with this.  i don't know much about impedance or watts.  so would purchasing the most common marshall cab work with these amps?  ie:  what wattage rating would i need to look for on the cab? 

thanks.
Report to moderator   Logged

Offline Walt-Dogg

  • Hero Member
  • *****
  • Posts: 567
Re: will this work?
« Reply #1 on: February 04, 2012, 10:25:41 pm »
Just about any Marshall; Both T's can handle 4, 8 or 16 ohm loads, just make sure the Marshall can handle at least 150 watts for the Original T and you set the load impedance to match the cab.
Report to moderator   Logged
Gibson Les Paul Special
Electra X260
Squier Precision Bass MIJ
Science Hellhawk 100w
Ampeg VT-22/V-4
Science Mother
Mojotone Bluesbreaker 2x12
Mojotone British 4x12
Ampeg SVT 810

Offline sunnsunnsunn

  • Jr. Member
  • **
  • Posts: 4
Re: will this work?
« Reply #2 on: February 05, 2012, 10:18:27 am »
thanks!
Report to moderator   Logged

Offline xsolarusx

  • Sr. Member
  • ****
  • Posts: 283
  • 416
    • Black Faxes
Re: will this work?
« Reply #3 on: February 06, 2012, 09:29:34 am »
Generally, I'm going to go 100% with what Walt said. However, some people really dig the sound of pushing their speakers via a higher-powered amp. Not the greatest idea if you're not familiar with your speakers and amp, but just thought I'd put that out there.
Report to moderator   Logged
(2) 73 1st Gen Model T
Late 70's Marshall JCM 800 1960B cab
Pages: [1]   Go Up
« previous next »