The sunn Forum

Sunn Musical Equipment => Q & A => Topic started by: Smoothwound on April 11, 2015, 01:20:06 pm

Title: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: Smoothwound on April 11, 2015, 01:20:06 pm
Hello Sunn people,

I have an ambitious dream, and I need some of your amazing minds and skill sets to help me figure it out.

In the spirit of the legendary Rolling Stones Mobil Recording Studio, and in the face of our limited funds to afford a proper space in which to record and play Live, I have come across this little beauty...

http://www.converdant.biz/plug-out/

Which I am hoping can allow our band, NWANML (pronounced, New Animal) to play wherever we want, and record as well. The problem is, I am not an electrician, or techi, and can't figure out if any of these can handle the power requirements need for a

Sunn 200s, Supro Dual Tone and or Thunderbolt and or Fender Twin Reverb, PA system (Mackie or similar) and possibly a light or two, macbook pro, apogee thunderbolt ensemble,

I'm asking you guys to recommend one of these models to handle all of this,
recording on location
playing on location

or to inform me that it won't work. If anyone could help me out, I would really appreciate this. I am good at many things, but this is not my skill set.

thanks,
Dave
Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: EdBass on April 11, 2015, 02:33:10 pm
A single 15A  circuit should handle the MI amps with the and/or scenario with ease, the question is the PA. What it takes is dependent on how many watts you will actually be using; not necessarily what the output of the system is rated at.
There is 1800 watts potential out of a 15A 120VAC circuit, which doesn't mean you are limited to total PA power amps rated at 1800 watts or less (HOPEFULLY you will rarely be using anywhere near the full output of the amps), but doesn't mean you can run a giant system full tilt on a single 15A circuit.
I run an A&H console, processing rack and four dual monaural Stewart World 2.1's at 8 ohms off of a single 15A circuit in 100-150 fire code venues all of the time without issues, plenty of juice. The amps are pretty much just idling, the only reason I use all 8 amps is that I run stereo bi-amped mains and 4 monitor mixes.
One VERY helpful hint: always run your entire PA rig, board effects amps, etc. on one circuit if at all possible. Look up "ground loop" for details.

So, what specifically are you running for PA power?
Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: Smoothwound on April 11, 2015, 03:18:53 pm
Yamaha Stagepas 300 for now,

So did you get a chance to look at the converdant site? http://www.converdant.biz/plug-out/

Maximum Output Power   150 W+150 W/6Ω @ 10% THD at 1kHz (SPEAKER L/R) 100 W+100 W/6Ω @ 1% THD at 1kHz (SPEAKER L/R)

Frequency Response   -3 dB, 0 dB, +1 dB @20 Hz.20 kHz, 1 W Output/6Ω (Without MUSIC/SPEECH, EQ and SP EQ Circuit) (SPEAKER L/R) -3 dB, 0 dB, +1 dB @20 Hz.20 kHz, +4 dBu 10 kΩ Load [MUSIC/SPEECH] switch=MUSIC (MONITOR OUT, REC OUT)
Total Harmonic Distortion   < @1 kHz, 50 W Output Power (SPEAKER L/R) < 0.5% @20 Hz.20 kHz, +14 dBu 10 kΩ (MONITOR OUT, REC OUT)
Hum & Noise   < 65 dBu Residual output noise (SPEAKER L/R) < -90 dBu Residual output noise (MONITOR OUT, REC OUT) < -67 dBu @ MONITOR OUT control & one CH LEVEL control at nominal level
Crosstalk   < -70 dB between input channels
Weight   18 kg (mixer and two speakers)
Power Consumption   70 W
Stereo Input channel Equalization   Shelving turnover/rolloff frequency: 3 dB before maximum cut or boost ± 15 dB HIGH 10 kHz shelving LOW 100 Hz shelving
Speaker   Enclosure   Bass-reflex type
Speaker Unit   LF: 8" (20 cm) Cone HF: 1" (2.54 cm) Compression Driver
Cross Over Frequency   4 kHz
Frequency Range   55 Hz - 20 kHz
Maximum Output Level   112 dB (1 m)
Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: Smoothwound on April 11, 2015, 04:48:30 pm
On another note Ed,

I have a chance to grab a 312 cabinet for 50$

How do you think it might pair with my 200s and cabinet?
Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: EdBass on April 12, 2015, 12:24:41 am
Oops, wasn't paying attention...

So let me make sure I "get it"; are you planning to use a hybrid automobile to power a live band? Right off the bat, kudos for thinking "out of the box"!

2-3 kilowatts should power your gear, but in my limited (as in ZERO) experience of using the generator capacity of a hybrid vehicle for anything other than possibly a short term, emergency AC source seems like a bad idea on the surface.
That type usage wasn't designed into the vehicle by the vehicle manufacturer, and I would bet money that it would void any warranty the vehicle came with from the factory.   
For around that kind of money, I would think your best bet would be a dedicated gas powered generator.

Again, all of this "advice" is off the top of my head, I've never even considered researching that concept!

I think any nice 312 cab for $50 is probably a deal, whether or not is sounds good with your rig depends on if YOU like the way it sounds or not. I'd roll the dice, it's only 50 bucks!

Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: Smoothwound on April 12, 2015, 11:00:11 am
All valid points,
My biggest concern was voiding the warranty, and I can't get anyone from converdant to respond. Probably think I'm crazy! they do have a FAQ section addressing this...kind of vague.

I thought it would be a great idea to be able to record and play in various outdoor acoustic locations, in the Spirit of the Rolling Stones Mobile Studio meets digital era. I was just concerned about the power demands of that 200s plus the rest of the band. I think these would be small, hit and run, shows, kind of pop-up concerts all around the area.

 I'll keep looking into it and let you know how it ends up.

Thanks for advice!! The 212 cab has PA replacement speakers, but still, I want it. I was just wondering if there are any threads about the sound characteristics. How is it different then 215's? Was it designed more for guitar than bass, and the like?

Dave
Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: EdBass on April 12, 2015, 11:59:33 am
All valid points,
My biggest concern was voiding the warranty, and I can't get anyone from converdant to respond. Probably think I'm crazy! they do have a FAQ section addressing this...kind of vague.

I thought it would be a great idea to be able to record and play in various outdoor acoustic locations, in the Spirit of the Rolling Stones Mobile Studio meets digital era. I was just concerned about the power demands of that 200s plus the rest of the band. I think these would be small, hit and run, shows, kind of pop-up concerts all around the area.

 I'll keep looking into it and let you know how it ends up.

Thanks for advice!! The 212 cab has PA replacement speakers, but still, I want it. I was just wondering if there are any threads about the sound characteristics. How is it different then 215's? Was it designed more for guitar than bass, and the like?

Dave

Yeah, I thought that the Converdant site was strong on sales hype, but very weak on hard info also... Contact the vehicle manufacturer, they will be the entity that ultimately decides whether or not your fried charging system will be covered under warranty.

As I said; I'm going with "No, as soon as that device is installed your powertrain/electrical warranty is voided".

Good idea though!
Title: Re: 21st century Mobile recording and LIVE rig- Power requirements?
Post by: Isaac on April 12, 2015, 11:29:34 pm
Smoothwound: 212 or 312? You've mentioned both.