The sunn Forum

Sunn Musical Equipment => DIY => Topic started by: jop120 on November 22, 2014, 11:16:52 pm

Title: Original Model-T Clone C21? can't read schematic
Post by: jop120 on November 22, 2014, 11:16:52 pm

Hi everyone, I just found out that Heyboer can make Model-T iron for a a fraction of the cost that MM charge, so I've ordered myself some and am sourcing parts for the build.

I'm just struggling to make out one part on the schematic, I think its C21 but can't really make that out either. It's the electrolytic that goes from Pin8 on V2 to the ground and parallels R13. I think it reads 22uf.

Does anyone know if this is correct or what it should be? also it'd only need to be about a 100v right?

Cheers very much
Josh

Title: Re: Original Model-T Clone C21? can't read schematic
Post by: loudthud on November 23, 2014, 08:53:20 pm

On the 1st generation Model T C21 should be 22uF 25V.

Title: Re: Original Model-T Clone C21? can't read schematic
Post by: jop120 on November 24, 2014, 12:31:22 am

excellent, thanks very much for clearing that up.

cheers,
Josh