2000s/350b head back panel dimensions

[rot gut]

Can someone post the dimensions for the back panel of a 2000s/350b head?

[rot gut]

nvm.

[Jeff Troy]

Hey, RG,

Working up a non-scale but dimensional drawing for you now. Probably will post shortly.

Warmest...

[Jeff Troy]

Here ya go. This should do it for you.

If you send an e-mail address, I can send you an 8.5x11-inch page. The drawing will be much easier to read.

Tap to jefftroy@aol.com.



Warmest regards...

[rot gut]

email sent, thanks.

[warandhairstyle]

email sent also.  Thanks!

[CLD]

I sent one as well. Thanks in advance, Jeff.

[CLD]

Does anyone have one of these diagrams they could send me? Thank you.

My main interest is the width (top to bottom) of the thin bar across the middle. My 2000S came with a DIY replacement that is too narrow (only 1.25"). Would someone with a 2000S measure that piece for me?

There was one post with a photograph large enough to see that indicates 2.125" for this piece - is that right? I saw 1.75" somewhere else, which is why I want to be sure. Thanks.

 

[Walt-Dogg]

That would explain the weird width of the DIY one if the previous also went by a diagram... I would go ahead and email Jeff though man, I'd trust him to get the dimensions right.

[CLD]

I e-mailed and PMd Jeff last month but didn't get any response, hence the post yesterday. He's always been super-responsive before so maybe he's been traveling or something recently.

[Jeff Troy]

Hi, Guys,

CLD, I thought I sent that two you and another member awhile ago.

Please send an e-mail to jefftroy@aol.com and I'll resend the diagram.

Warmest regards,

[CLD]

E-mail sent. Thanks, Jeff.

[Jeff Troy]

Hi, Carter,

Sent dimensions yesterday. Did the attachment come through?

Warmest...

[CLD]

Yes, they did, thanks!