« previous next »
Pages: [1]   Go Down

Author Topic: neutering a concert bass and an acoustic 370  (Read 2342 times)

0 Members and 1 Guest are viewing this topic.

tj

  • Guest
neutering a concert bass and an acoustic 370
« on: February 23, 2003, 10:36:44 pm »
would it be possible to gut the power sections out of both of these amps and use them as preamp heads, running the preamp outs into a new stereo power amp (300+ watts per side) to drive two cabs in a biamp setup?
Report to moderator   Logged

Offline JoeArthur

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 729
neutering a concert bass and an acoustic 370
« Reply #1 on: February 24, 2003, 10:12:37 am »
Anything's possible, but I wouldn't bother with major surgery.

I don't know about the 370, but I would be surprised if it didn't have the same setup as the concert...

Meaning, the concert has a power amp in jack in back.  Use the preamp out to the new power amp, and put a "shorting plug" in the power amp in jack to ground the input of the internal power amp.  A "shorting plug" is just a plug with the tip connected and soldered directly to the sleeve.
Report to moderator   Logged

tj

  • Guest
neutering a concert bass and an acoustic 370
« Reply #2 on: March 01, 2003, 12:41:23 am »
could I use a 1/4" patch cord (plugging one end of it into the power amp in and leaving the other end of the patch cord hanging free)? Or does it have to be a "grounding plug"?
Report to moderator   Logged

Offline JoeArthur

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 729
neutering a concert bass and an acoustic 370
« Reply #3 on: March 06, 2003, 02:26:58 pm »
You probably could... but the unterminated end would be picking up some sort of hum and noise (like when you haven't plugged in your instrument yet but the cord is plugged into the amp) and attempting to amplify it to some extent.  

Grounding the input is really best.
Report to moderator   Logged
Pages: [1]   Go Up
« previous next »