« previous next »
Pages: [1]   Go Down

Author Topic: Another 300T question....  (Read 2314 times)

0 Members and 1 Guest are viewing this topic.

Offline MatthewRedStars

  • Jr. Member
  • **
  • Posts: 7
    • http://www.redstarsparade.com
Another 300T question....
« on: February 18, 2006, 05:40:21 pm »
My 300T seems to severely lack clean headroom, i use a distorted tone anyway but something is obviously awry.

Even with all the knobs low (say 3-4) and the input pad engaged there is audible musical distortion in Channel 1.

Any easy things to check? Bad valves? Pre or power?

Any advice would be appreciated

m.
Report to moderator   Logged

Offline Isaac

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1,904
Another 300T question....
« Reply #1 on: February 18, 2006, 06:57:29 pm »
What kind of bass are you using? Active or passive? That's probably not the problem, but it could be affecting it.
Report to moderator   Logged
Isaac

Offline MatthewRedStars

  • Jr. Member
  • **
  • Posts: 7
    • http://www.redstarsparade.com
Another 300T question....
« Reply #2 on: February 19, 2006, 03:55:33 am »
I'm using a active Stingray.
Report to moderator   Logged

Offline Isaac

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1,904
Another 300T question....
« Reply #3 on: February 19, 2006, 08:18:58 am »
Here's one possibility.

In most tube amps, Sunns for sure, the input goes first to an amplifier stage, then the volume control. Because of this, it's possible to overdrive the first stage with a hot input, yet keep the volume low overall. Try turning the volume down on the bass, or using a different, preferably passive, one. If doing this allows you to turn up higher, ang gets you a clean sound, then you might well be overdriving the input stage.
Report to moderator   Logged
Isaac
Pages: [1]   Go Up
« previous next »