Author Topic: SUNN model 8 cabinets...  (Read 3274 times)

0 Members and 4 Guests are viewing this topic.

Offline joe changle

  • Jr. Member
  • **
  • Posts: 8
SUNN model 8 cabinets...
« on: October 01, 2000, 05:21:00 pm »
I have 2 sunn model 8 pa cabinets that i use in my dj business..these cabinets are great and are all original except for the speaker (i got them empty)..could anyone tell me what the wattage rating was for them and where i might get more info on the crossover used in them?

thanks!!!

Offline Don T.

  • Sr. Member
  • ****
  • Posts: 488
SUNN model 8 cabinets...
« Reply #1 on: October 04, 2000, 07:14:00 pm »
Hello;
 The model 8 speakers were one of my favorite cabinets too. They were stuffed with 81-0145 speakers of Sunn manufacture. The had 2" voice coil 54 ounce square magnet and a fz of about 55hz. they would probably benefit from a lower fz around 40 to 45hz but don't go too low cuz the vc may hit the back plate from improper acoustic loading. They were what we called "tight" in the low end and were mainly used for superb vocal support or side fills. The horn was an RCF (italian made) with an RCF driver of which I have 2 (NOS). They came equipped with those early piezo tweeters which lisped badly at 4k and would benefit from a later, smoother replacement. As for the x-over the peizos had a 50 ohm resistor and I would have to find some documents (which I should posses) cuz the values escape me at the moment but I think it was a 12 db/oct design. I will have to look around and e-mail you later   Don T.
Don T.

If it's too loud, you're too old.

Offline Joe

  • Full Member
  • ***
  • Posts: 74
SUNN model 8 cabinets...
« Reply #2 on: October 05, 2000, 07:03:00 am »
don..
thanks for the reply..i bought them empty (no woofers) and placed 300watt rms drivers into them..sound great..love the cabinets..

run a crown micro-tech 1200..never had a problem with the piezzos..looking for a couple more..or some model 10's!

thanks again!

joe!