« previous next »
Pages: [1]   Go Down

Author Topic: Series or paralell  (Read 2068 times)

0 Members and 1 Guest are viewing this topic.

Offline eotpr

  • Full Member
  • ***
  • Posts: 23
Series or paralell
« on: February 26, 2007, 02:54:23 pm »
Ok guys,
     Are cabinets usually wired in series or paralell, and if I hook to the outlet jack on one cabinet to the inlet of another cabinet am I hooking them in series or paralell?  If the cabinets are wired in paralell then the speakers between the two cabinets would either be series paralell or straight series.  Am I making sense?  I have two 500W yamahas and two 500 watt mackies and I want a good amp to push them in a pa and mixer system.  Did Sunn make anything that would work for this?  I would assume I would need about a 2000 watt amp to push the 500watt speakers at full capacity if the cabinets are 8 ohm cabs.  However if they are connected in paralell then it would only take about 1000 Watts because two 8 ohm loads in paralell would give a 4 ohn load right?  Where if they were in series it would give me a 16 ohm load and I would need about a 4000 watt amp.  Any thoughts? :-o
Report to moderator   Logged

Offline JoeArthur

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 729
Re: Series or paralell
« Reply #1 on: February 26, 2007, 03:54:09 pm »

Read your owner's manual?  :?
Report to moderator   Logged

Offline Isaac

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1,904
Re: Series or paralell
« Reply #2 on: February 26, 2007, 05:23:38 pm »
If you're talking about daisy chaining, assume parallel unless it is specifically noted that a jack is a  series out.
Report to moderator   Logged
Isaac

Offline eotpr

  • Full Member
  • ***
  • Posts: 23
Re: Series or paralell
« Reply #3 on: February 27, 2007, 07:25:50 am »
Assuming paralell makes a lot of sense.  Is therre a sun power amp that might work for this application?
Report to moderator   Logged
Pages: [1]   Go Up
« previous next »