« previous next »
Pages: [1]   Go Down

Author Topic: Anyone have internal Sunn 200s hi res picture?  (Read 2428 times)

0 Members and 2 Guests are viewing this topic.

Offline ddm

  • Jr. Member
  • **
  • Posts: 11
Anyone have internal Sunn 200s hi res picture?
« on: April 03, 2008, 10:14:29 am »
I would greatly appreciate it..

Thanks!
Dennis
Report to moderator   Logged

Offline Soundmasterg

  • Hero Member
  • *****
  • Posts: 745
Re: Anyone have internal Sunn 200s hi res picture?
« Reply #1 on: April 03, 2008, 02:31:41 pm »
I've got some at home...can email to you later if you want.

Greg
Report to moderator   Logged

Offline loudthud

  • Administrator
  • Hero Member
  • *****
  • Posts: 1,171
Re: Anyone have internal Sunn 200s hi res picture?
« Reply #2 on: April 03, 2008, 03:40:28 pm »
These pics aren't very high res but show the parts of the bias supply in the other thread.
Report to moderator   Logged

Offline ddm

  • Jr. Member
  • **
  • Posts: 11
Re: Anyone have internal Sunn 200s hi res picture?
« Reply #3 on: April 04, 2008, 08:59:14 am »
Loud...

Thanks for the pics..

I have 47 ohm heater to ground reference resistors.. If i put a new trans in.. should i keep those?

Also, im sure a new trans will have a 3 wire primary.. Is that hard to redo on a 200s?

Thanks
Dennis


Greg

Id appreciate whatever you can send me..

Thanks!
Report to moderator   Logged

Offline mckinnon audio

  • Sr. Member
  • ****
  • Posts: 404
Re: Anyone have internal Sunn 200s hi res picture?
« Reply #4 on: April 04, 2008, 01:26:29 pm »
  Hi there,your trans. will only have 2 wires on the AC primary,the incoming AC gnd. will go to the chassis.If you're not going to connect the htr.winding gnd./center tap,leave the resistors in,they'll save the trans. if one of your htr's shorts to gnd. Good luck Mel.
Report to moderator   Logged
Pages: [1]   Go Up
« previous next »