« previous next »
Pages: [1]   Go Down

Author Topic: Sunn Sorado  (Read 2563 times)

0 Members and 1 Guest are viewing this topic.

Brandon

  • Guest
Sunn Sorado
« on: November 15, 2002, 06:46:47 am »
I have a Sorado I just bought. I can't figure out what preamp tube I need. I looked at the side of the tube and the writing says Mullard but the tube type number is not there.  I looked at some schematics for the sorado and it looks like they have been through a few revisions because the one I saw was a little different from what I have.  I tried a 12AX7 in the amp and all the amp would do is hum.  I know the 12AX7 is good because I put it in another amp and it worked.  Does anybody have any info on this amp?

Brandon
Report to moderator   Logged

Offline Bill Matthews

  • Full Member
  • ***
  • Posts: 89
Sunn Sorado
« Reply #1 on: November 17, 2002, 08:38:34 pm »
Yeah, I think the one you're missing is a 6AN8
Report to moderator   Logged
May ALL your days be SUNN-Y days

Offline Bill K.

  • Full Member
  • ***
  • Posts: 37
Sunn Sorado
« Reply #2 on: November 25, 2002, 11:03:31 pm »
Hi Brandon, check out the schematic on this site for the tubes you'll need. Good luck!
Report to moderator   Logged

Offline made by hand

  • Sr. Member
  • ****
  • Posts: 158
TUBE ID
« Reply #3 on: April 13, 2003, 07:03:49 pm »
THE TUBES IN YOUR SORADO ARE SET UP THE SAME AS A 200S..THE AMP IS THE SAME EXCEPT FOR THE FACE PLATE
Report to moderator   Logged
Pages: [1]   Go Up
« previous next »