« previous next »
Pages: [1]   Go Down

Author Topic: coliseum problem  (Read 2262 times)

0 Members and 1 Guest are viewing this topic.

Anonymous

  • Guest
coliseum problem
« on: July 14, 2005, 03:24:17 pm »
I recently bought a coliseum slave (the 300 watt one with the vu meter in the front) and I have question about how to run it.   I am assuming that you only use a preamp signal to be amplified when you use this amp.
heres the problem- when I use a preamp signal, there is hardly any sound at all. However, and I know you're not supposed to do this, when I use the speaker out from my main amp to the input on the slave, it is super loud.  just wondering if there is any simple fix for this or if I am looking at an expensive visit to the amp guy.

anything would help -thanks
Report to moderator   Logged

Offline Isaac

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1,904
coliseum problem
« Reply #1 on: July 14, 2005, 10:10:59 pm »
I know this is silly, but have you tried turning the attenuator down (volume up)?
Report to moderator   Logged
Isaac

Anonymous

  • Guest
coliseum problem
« Reply #2 on: July 15, 2005, 02:55:51 pm »
yeah, i can crank it all the way and its still really quiet.
Report to moderator   Logged

Offline Isaac

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1,904
coliseum problem
« Reply #3 on: July 17, 2005, 05:09:07 pm »
My best guess is that there must be a mismatch between the two pieces of equipment, such that the slave requires a much higher signal to reach full output than the amp is putting out. Those specs should be in the spec sheets for the respective equipment, if you can find them.
Report to moderator   Logged
Isaac
Pages: [1]   Go Up
« previous next »